Device handler MH-250
Features:
Main picture shows configuration with bowl-feeder and BIN-Output and fixed footing setup
Possibility for integration of programming, device marking labeling units
Stand-alone mobile support with adjustment for slope angle and height
Special demand contacts, also for fine pitch leads, HF, HV, HC
Various contacts: (non Kelvin, Kelvin)
Cooling without LN₂, LCD Touchscreen display
Specifications:
Throughput (including contact action): Up to 3500 devices/hour
Input capacity: 5 tubes standard / bowl feeder opt max. 5 customized (depending on tube width)
Output capacity: up to 5 tubes / canister (5 BIN sod max.)
DUT position: height 850mm to 1200mm (33.5 “to 47.5) angle 30° to 50° or fixed at 90 degree
Tester Interface (D-SUB 25 and D-Sub 9): parallel test (5 BIN inp.) / serial test (RS232)
Dimensions (width x depth x height): 600 x 800x 1500mm (23.6″x 31.5″x 60)
Weight: 130 kg ( 2861bs. )
Pneumatic requirements: 61/s at 5 to 10 bar (5.3 SCFM at 72 to 145 psi)
Electrical power requirements: 230 VAC. 50/60 Hz, 1300 W
Available kits for standard packages: MLP, QFN, SO, TSSOP, QSOP, SSOP, SOT, TO, SIP, SIP, ZIP, PLCC, LCC, DPAK and others
Device dimensions: min. max.
Device width 2.0 mm (78 mil) 30.5 mm (1200mil)
Device height 0.6 mm (23 mil) 15.0 mm (590 mil)
Device length 2.0 mm (78 mil) 72.0 mm (2384 mil)
Temperature control range: -55°C to +155°C (remote controlled in online operation by an additional, external thermostreamer)
Temperature conrol accuracy +/- 1C at DUT location
Soak time setting rate 0 to 999 seconds